<< Click to Display Table of Contents >> Navigation:  Multiple Users > SpecView Networking via Modem - General

 

Although this is unlikely these days - in situations where a LAN or WAN or Internet connection between the Local & Remote(s) is not appropriate; SpecView Remote can be used to dial directly into the Local.

 

If more than one simultaneous connection is needed then more than one modem will need to be connected to the Local, each with a different telephone number.

 

However, for this SpecView relies on having modems which have themselves been correctly configured, PLEASE REFER TO THE MODEM'S USER GUIDE. Then test the modem connection using Hyperterminal.

 

SpecView should work with all makes of data modems, but it has been found that some combinations work better than others, these are listed under Modem types.

 

Additionally it is important that the SpecView project has been setup so that both ends have sufficient information to be able to make a successful dial-up connection.

 

Multiple Users via Modem - Setup

Multiple Users via Modem - Failure

Multiple Users via Modem - Using HyperTerminal

Multiple Users via Modem - Modem Types

Multiple Users via Modem - TAPI Versions