<< Click to Display Table of Contents >> Navigation:  Installation and Starting SpecView > Instrument Definition/Detection > Address Help > Yokogawa UT2400 & UT2800 Controllers

 

Note: Driver defaults to 8 Databits, No Parity, 1 Stop Bit

 

Note, AutoDetect will assume 0 decimal places when detecting instruments.

 

Format is:

 ACP

Where:

A:        Single Digit HEX address of controller as defined by the rotary switch on the back, range is 0 to F

C:        Channel number, 1 to 8  (1 to 4 for UT2400)

P:        Precision of user defined items: 0 / 1 / 2 / 3

 

The CPU view can be defined on any channel 1-8.

 

Examples:

011        - Address 0, Channel 1, 1 Decimal

F80        - Address F, Channel 8, 0 Decimals

 

Driver Command Support:

 

This driver supports the following driver commands:

TTL=x                Set Time To Live to x tenths of a second, Eg TTL=5 means half of a second.