<< Click to Display Table of Contents >> Navigation:  Using SpecView in Runtime Mode > Runtime Menubar > Options Menu

 

 

Short Param List

This menu command toggles the parameter list on Instrument Views between Short List and Full list modes. Full List mode lists ALL the parameters for the instrument, whereas Short List mode displays just some of the most frequently used parameters.

NOTE: Full List mode is not the same as the Full Names checkbox on the Parameter List dialog, which toggles between Full variable names and abbreviated variable names.

Access to the Full Parameter List can be restricted by Password Log In Level

 

Setup COM Port

Displays the COM Port Setup box and allows the COM port(s) settings to be changed, and driver commands added, during Runtime.

 

 

Toggle DEBUG on COM1

Enable/disable debug information on COM1 by setting the driver command: DEBUG=1

It is not recommended to change this setting unless under the direction of a SpecView representative.

 

Toggle DEBUG on COM2

Enable/disable debug information on COM2 by setting the driver command: DEBUG=1

It is not recommended to change this setting unless under the direction of a SpecView representative.